Utes Sample Terrain is invisible in buldozer but map items look ok.

[six_ten 35]

I set up my DayZ Workdrive as T since I use P drive for ARMA modding. 

Terrain Builder -> Tools -> Preferences -> User Settings -> Paths as follows:

Data Directory:  T:\

Project Directory:  T:\Samples\Test_Terrain

Libraries Directory:  TemplateLibs

Terrain Builder -> Tools ->  Preferences -> Buldozer  as follows:

exe filepath:  C:\Program Files (x86)\Games\Steam\SteamApps\common\DayZ\DayZ_x64.exe

Launch Parameters:  -buldozer -window -nopause -mod= -profiles=T:\Buldozer -name=Buldozer

Data Directory:  T:\

The Extracted DZ files are in T dir.  I extracted the Utes Sample terrain into the T drive.  When I open project with Terrain Builder  T:\Samples\Test_Terrain\source\utes.tv4p the map loads okay (though there are many unused templates).  When I run bulldozer the map loads and everything seems okay except the terrain is invisible.  It exists; that is, as I navigate and check elevations I can see the change, but no terrain is visible, just trees rocks buildings etc floating as if on the terrain in correct locations.  Water is visible too, just no land.

 

How can I fix this?

 

 

[six_ten 35]

I think its fixed -- rebuilt all layers and terrain.

[six_ten 35]

Well I can see it in Buldozer now, but after following the directions at https://community.bistudio.com/wiki/DayZ:Terrain_sample    DayZ crashes and says "Cannot load world 'samples\test_terrain\world\utes.wrp'

Has anyone succeeded in running the sample terrain?

[nigrum.cattus 0]

I have the same error and I couldn't fix it :(